# Tasks Work in order. Finish a task's check before starting the next. 1. **Set up.** Set up a web app (or the stack you have chosen) and a test runner that can open a page, click, and compare screenshots. Read `spekkr.inputs.json` first. Check: a blank or heading page loads, and an empty test run passes. 2. **The building (R1).** Build what `R1. The building` asks for, to the numbers in `design.md`. In particular: Shafts are 2.4 m wide and 0.4 m apart. Each floor is 3.2 m high, with a 0.2 m slab. Check: the `R1. The building` acceptance checks pass. 3. **Motion (R2).** Build what `R2. Motion` asks for, to the numbers in `design.md`. In particular: A command to a floor accelerates, cruises, and decelerates so the cabin stops at that floor's sill, within 0.01 m, with speed 0. Check: the `R2. Motion` acceptance checks pass. 4. **Collisions and doors (R3).** Build what `R3. Collisions and doors` asks for, to the numbers in `design.md`. In particular: Two cabins in the same shaft may not overlap. A command that would cause an overlap is refused, and the cabin already moving keeps its plan. Check: the `R3. Collisions and doors` acceptance checks pass. 5. **Recording (R4).** Build what `R4. Recording` asks for, to the numbers in `design.md`. In particular: One command writes a headless recording: a JSON trail of cabin positions each step, and a 5-second frame sequence at 30 frames a second for the fixture run. Check: the `R4. Recording` acceptance checks pass. 6. **Files (R5).** Build what `R5. Files` asks for, to the numbers in `design.md`. In particular: The build has no network. Units only change labels. Check: the `R5. Files` acceptance checks pass. 7. **Goldens.** Capture the frames named in `design.md` at the defaults, with motion frozen where the file says so. Compare them within the stated tolerance. Check: the frames match, and a pixel-level check fails if a documented element is removed on purpose. 8. **Finish.** Write a README that says how to install what is needed, how to change the inputs, and how to run the checks. Run the one command from a clean folder. Check: every item under Definition of done in `spec.md` is true.