# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Joints Shoulders, elbows, hips, knees, head, and optional wrists. Axes and rest angles are `fixtures/figure-joints.json`. The action pose is a lunge with one arm raised, angles in the pose file. ## Collision A snap's male/female pair may overlap by up to 0.05 mm in the contact band; other overlaps fail. The file lists the allowed contact pairs. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `height` | Height, mm | 150 | From 80 to 220, the T-pose height. | | `clearance` | Joint clearance, mm | 0.25 | From 0.15 to 0.4, the snap-fit gap. | | `wall` | Wall thickness, mm | 2.0 | From 1.4 to 3. | | `hands` | Separate hands | on | A wrist snap; if off, hands are merged. | | `stand` | A simple stand | on | A peg stand at the feet. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres and degrees. `height` is 150 (T-pose, feet to scalp), `clearance` is 0.25, `wall` is 2.0, hands and stand are on. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | T-pose height | 150.00 | 0.20 | `height` | | Snap-fit gap at each joint | 0.25 | 0.02 | `clearance` | | Wall thickness | 2.00 | 0.10 | Except a documented hinge film, 1.2 | | Allowed contact overlap | 0.05 | 0.01 | Only listed male/female pairs | | Joints in the T-pose | head, two shoulders, two elbows, two hips, two knees, two wrists | — | Wrists omitted if `hands` is off | The action pose is a lunge with the right arm raised. Rest and pose angles live in this file's joint table if a build does not ship `fixtures/figure-joints.json`. Shoulders ±0/80, elbows 0/90, hips 0/35, knees 0/70, right shoulder raised 110 in the action pose, units degrees. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/t-pose.png` | Figure 150 mm T-pose | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Joint axes and snap-fit clearances are measured. A scripted pose is checked for illegal self-intersection. Minimum wall thickness is measured. T-pose and posed renders are written. The tactile feel of a printed snap is out of scope. No physical print is required.