# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Tooth counts The train is listed in `fixtures/clock-teeth.json` (for example 8, 60, 64, 8… — the file is the authority) so that minute to hour is 60:1. Module, pressure angle 20 degrees, and backlash are in the same file. ## Escapement A simple recoil or dead-beat as chosen in the file, with impulse angles and a pallet clearance. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `module` | Module, mm | 1.0 | The gear module, from 0.6 to 1.5. | | `thickness` | Face width, mm | 3.0 | From 2 to 6. | | `bore` | Axle bore, mm | 3.1 | From 2.0 to 6.0, the hole in a gear. | | `escapement` | Include an escapement | on | A simple recoil or dead-beat, as in design.md. | | `hands` | Hour and minute hands | on | Hands on the 12:1 or 60:1 shafts, as documented. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres and teeth. Default module 1.5, min teeth 12, escapement and hands on. The going train is original. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Module | 1.50 | 0.01 | All meshing gears share it | | Minute-hand ratio | 1:60 | exact | From the escapement or seconds shaft | | Hour-hand ratio | 1:12 | exact | From the minute shaft | | Centre distance, meshing pair | m*(z1+z2)/2 | 0.05 | For each documented pair | | Escapement impulse angle | 6 deg | 1 deg | When `escapement` is on | A script turns the escape wheel 60 steps and asserts the minute hand moved 6 degrees and the hour hand 0.5 degrees. Backlash is at most 0.15 mm at the pitch circle. Print as separate gears and a frame, or as a documented assembly. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/front.png` | Going train module 1.5, hands at 12:00 | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Gear ratios (including a 60:1 minute-to-hour path) are exact as tooth-count products. A stepped-angle mesh shows no illegal tooth interference. Axle and bore dimensions match the file. Assembly renders are written. Timekeeping on the wall is out of scope. No physical print is required.