# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Click A click is `360 / teeth` degrees. The tooth profile and the expected min-distance at rest, mid, and click are `fixtures/clicker-sweep.json`. ## Mesh The exported STL is one printable piece. Voids are the gaps. Min wall 1.6 mm except the tooth tip (1.2 mm). ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `length` | Body length, mm | 60 | From 40 to 90. | | `gap` | Print-in-place gap, mm | 0.3 | From 0.2 to 0.5, the as-printed clearance. | | `teeth` | Tooth count | 12 | From 8 to 18. | | `cap` | A closed cap | on | A cap over the teeth, also print-in-place. | | `lanyard` | A lanyard hole | on | A 4 mm hole at one end. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres and degrees. `length` is 60, `gap` is 0.30, `teeth` is 12, cap and lanyard are on. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Body length | 60.00 | 0.10 | `length` | | Print-in-place gap | 0.30 | 0.02 | `gap` | | Click angle | 30.00 deg | 0.50 deg | `360 / teeth` | | Tooth tip minimum wall | 1.20 | 0.10 | Elsewhere 1.60 | | Lanyard hole | 4.00 | 0.10 | Through, at the cap end | The exported STL is one printable piece. Voids are the gaps. A kinematics sweep of one click has a documented min-distance at rest, mid-click and the click event; the build records those three distances. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/closed.png` | Clicker 60 mm, 12 teeth | | `shots/exploded.png` | Body and print-in-place wheel, parted | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Print-in-place gaps and tooth interference or clearance are measured, and a kinematic sweep of the click travel is checked against a file. Renders are written. Tactile feel is not a CI check. No physical print is required.