# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Segments A count and the rest length of each, scaled so the total is `length`, in `fixtures/axolotl-segments.json`. The envelope is a max angle per joint (for example 25 degrees), in the same family of files. ## Collision Allowed contact is only at the designed links, with a 0.05 mm band. Other overlaps fail. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `length` | Length, mm | 180 | From 100 to 260, nose to tail tip in the rest pose. | | `gap` | Segment gap, mm | 0.3 | From 0.2 to 0.45. | | `wall` | Wall thickness, mm | 1.8 | From 1.2 to 3. | | `gills` | External gills | on | Three pairs of gill stalks, print-in-place or fused as in design.md. | | `stand` | A small stand | off | A peg under the chest. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres. Default length (nose to tail tip, relaxed) is 180, segment count 16, `gap` 0.30, gills on, stand off. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Relaxed length | 180.00 | 0.40 | Along the body centreline | | Segment count | 16 | 0 | Head and tail included | | Print-in-place gap | 0.30 | 0.02 | Between living hinges or balls | | Gill pairs | 3 | 0 | When `gills` is on | | Minimum wall | 1.60 | 0.10 | Except a documented hinge film, 0.8 | A bend of the body to a 60 mm radius must not cause a self-intersection except in listed hinge contact. The mesh is one printable piece. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/relaxed.png` | Flexi axolotl 180 mm, 16 segments | | `shots/bent.png` | Body bent, gills on | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Segment clearances and a documented bend envelope are checked so an in-range bend does not intersect illegally. Wall thickness is measured. Rest and bent renders are written. No physical print is required.