# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Ratios (of `length`) Head 0.22, hip height 0.28, tail 0.48, forelimb 0.08, as in `fixtures/trex-measures.json`. Segment count and the bend envelope (max angles) are in the same family of files. ## Collision Same rule as other articulated animals here: only designed link contact, 0.05 mm band. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `length` | Length, mm | 200 | From 120 to 300, nose to tail in the rest pose. | | `gap` | Segment gap, mm | 0.3 | From 0.2 to 0.45. | | `wall` | Wall thickness, mm | 2.0 | From 1.2 to 3. | | `arms` | Tiny arms | on | The short forelimbs, poseable or fused as in design.md. | | `base` | A name base | off | A small plaque under the feet. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres. Default length (snout to tail tip, relaxed) is 200, stand-off height to the hip 70, `gap` 0.30, arms on, base off. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Relaxed length | 200.00 | 0.40 | Snout to tail tip | | Hip height | 70.00 | 0.30 | Ground to hip centre | | Print-in-place gap | 0.30 | 0.02 | Between segments | | Forelimb length | 18.00 | 0.20 | When `arms` is on | | Minimum wall | 1.60 | 0.10 | Except a documented hinge film, 0.8 | The mesh is one printable piece. A pose with the jaw open 25 degrees and the tail curved is documented as the display pose. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/display.png` | Flexi T. rex 200 mm, jaw open | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Clearance, bend-envelope, and printability checks of the same class as the articulated axolotl are run against this figure's own dimensions and pose file. Rest and bent renders are written. No physical print is required. The id and the name do not use a trademarked toy brand.