# Tasks Work in order. Finish a task's check before starting the next. 1. **Set up.** Install the tool in the `tool` input (CadQuery or OpenSCAD) and a mesh library for the checks. Read `spekkr.inputs.json` into one place at the top of the model. Check: an empty or trivial model is written and read back, and the inputs are visible in that source. 2. **Pitch and cells (R1).** Build what `R1. Pitch and cells` asks for, to the numbers in `design.md`. In particular: The plate's cell centres are `pitch` apart in X and Y. A `bins_x` by `bins_y` plate's overall size matches the formula in `design.md` within 0.05 mm. Check: the `R1. Pitch and cells` acceptance checks pass. 3. **Pockets, lips, meshes (R2).** Build what `R2. Pockets, lips, meshes` asks for, to the numbers in `design.md`. In particular: If `magnets` is on, each pocket is a cylinder of the diameter and depth in `design.md`, at the documented centres, and does not break through the plate. Check: the `R2. Pockets, lips, meshes` acceptance checks pass. 4. **Files and frames (R3).** Build what `R3. Files and frames` asks for, to the numbers in `design.md`. In particular: Parts: `plate` and `bin` as STL (and STEP if CadQuery). A report lists bounding boxes, volumes, and pass or fail against `design.md`. Check: the `R3. Files and frames` acceptance checks pass. 5. **Inputs (R4).** Build what `R4. Inputs` asks for, to the numbers in `design.md`. In particular: Numeric inputs are read from `spekkr.inputs.json` and must stay inside the ranges in the Inputs table in `design.md`. Check: the `R4. Inputs` acceptance checks pass. 6. **Goldens and the report.** Render the documented views of the default model. Run the one-command report at the defaults, at the person's inputs, and at one more legal set. Check: the report says pass throughout, and the rendered views are written next to the model. 7. **Finish.** Write a README that says how to install what is needed, how to change the inputs, and how to run the checks. Run the one command from a clean folder. Check: every item under Definition of done in `spec.md` is true.