# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Hex grid Odd rows are offset by `pitch/2` in X. Overall width and height are in `fixtures/hex-wall-measures.json`, with volumes and the hook/bin clearances (0.2 mm radial, 0.3 mm depth). ## Mesh checks Watertight, min wall `wall`, print position: wall flat on the back face, hook standing, bin open up. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `pitch` | Hex pitch, mm | 40 | Centre to centre, from 28 to 60. | | `wall` | Wall thickness, mm | 2.4 | From 1.6 to 5. | | `rows` | Rows | 5 | From 2 to 12. | | `cols` | Columns | 8 | From 2 to 16. | | `hooks` | Include a hook accessory | on | A hook that seats in a cell with the documented clearance. | | `bin` | Include a small bin | on | A bin that seats in a cell. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres. `pitch` is 40, `wall` is 2.4, `rows` is 5, `cols` is 8, and both accessories are on. Odd rows are offset by `pitch/2` in X. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Cell centre distance (pitch) | 40.00 | 0.05 | Flat-to-flat neighbours | | Wall panel thickness | 2.40 | 0.05 | `wall` | | Hook seating radial clearance | 0.20 | 0.02 | Hook in a cell | | Bin seating depth clearance | 0.30 | 0.05 | Bin in a cell | | Minimum wall in the mesh | 2.40 | 0.10 | Except a documented hook tip, 1.6 | Print position: the wall lies on its back face, the hook stands, the bin opens up. Each exported mesh is manifold and watertight. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/wall.png` | Hex wall 5 × 8 cells, 40 mm pitch | | `shots/assembly.png` | Wall with hook and bin seated | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Hex pitch, hook and bin insertion clearances, and wall thickness are measured on generated meshes. A rendered wall with a few accessories mated in place is written. Meshes are manifold. No physical print is required.