# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Tables `6mm-d`: diameter 6.0, D-flat height 5.5 (0.5 mm from the opposite tangent — the file states the exact convention). `quarter-inch`: 6.35 mm, D-flat as in `fixtures/knob-shafts.json`. ## Press The bore is smaller than the shaft by `press` on the diameter (or on the radius, as the file says; tests use the file). ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `diameter` | Skirt diameter, mm | 16 | From 10 to 28. | | `bore` | Shaft bore, mm | 6.0 | The round shaft, before the D-flat, from 3.0 to 6.5. | | `press` | Press-fit allowance, mm | 0.05 | How much tighter the bore is than the stated shaft, from 0 to 0.12. | | `height` | Height, mm | 12 | From 8 to 20. | | `dflat` | A D-flat | on | A flat on the bore, as in the stated standard. | | `pointer` | A pointer line | on | A mark on the skirt. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | | `standard` | Shaft standard | 6mm-d | The documented shaft table in design.md. | ## Acceptance at the defaults Millimetres. Default skirt diameter 12.0, height 14.0, shaft bore 6.0, D-flat and pointer on. This is an original knob family, not a branded module standard. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Skirt diameter | 12.00 | 0.05 | Of the default 'round' knob | | Height | 14.00 | 0.05 | Shaft shoulder to crown | | Bore diameter | 6.00 | 0.02 | For the shaft | | D-flat depth | 0.50 | 0.02 | When `dflat` is on | | Pointer line width | 0.40 | 0.05 | When `pointer` is on | Three shapes ship: round, knurled, and winged. Each has a documented volume within 0.5% and a bore that accepts a 6.00 mm shaft with 0.05 mm clearance. The set is one project, three STLs. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/set.png` | Three knobs 12 mm skirt, D-flat bore | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Shaft bore and D-flat dimensions are measured against a stated standard table, with a press-fit allowance applied. A family of sizes is rendered. No physical press and no real module are required. The id does not use a trademarked format name.