# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Balance Assuming density 1, the vector of first moments about the axis, divided by mass and by `diameter`, is under 0.01 (a 1% relative offset), as in `fixtures/prop-balance.json`. ## Sweep 36 steps of 10 degrees. Allowed contact is only the axle journal, at clearance `gap`. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `diameter` | Diameter, mm | 80 | From 40 to 140, the blade tip circle. | | `gap` | Axle gap, mm | 0.3 | From 0.2 to 0.5, the print-in-place clearance. | | `blades` | Blade count | 3 | 2, 3 or 4. | | `hub_cap` | A hub cap | on | A print-in-place cap over the axle. | | `stand` | A small stand | on | A stand the prop can spin on, in a desktop model. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres. Default diameter 120, blade count 3, hub bore 8, hub cap and stand on. The blades and hub are one print-in-place part. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Prop diameter | 120.00 | 0.20 | Tip to tip | | Blade count | 3 | 0 | Evenly spaced | | Print-in-place axle gap | 0.30 | 0.02 | Hub to axle | | Hub bore | 8.00 | 0.05 | If the stand pin is used | | Stand pin height | 20.00 | 0.10 | When `stand` is on | A kinematics check spins the prop 360 degrees about the axle with no intersection except the documented gap. The part is printable as a single piece on its back face, blades flat. This is a display model, not a flying prop; no balance or thrust claim is made. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/on-stand.png` | Prop 120 mm, three blades, on stand | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Axle and hub clearance, a rotational sweep without illegal intersection, and approximate mass balance (moments about the axis) are checked on the model. Renders are written. Flight is out of scope. No physical print and no motor are required.