# Print-in-place prop ## What this builds A propeller on an axle, designed to print in one piece, modelled as code. The axle gap is measured so the print does not weld. A rotational sweep of the blades clears the stand and the cap, with no illegal intersection. An approximate mass balance (first moments about the axis, assuming uniform density) is within a documented bound. Renders are written. Flight, thrust, and a motor are out of scope. Read `spekkr.inputs.json` first. `diameter` is the tip circle. `gap` is the axle clearance. `blades` is the count. `hub_cap` and `stand` add features. `tool` is the modeller. ## Out of scope - Flight, thrust, a motor, or a wind-tunnel test. - A physical print, or a balance on a real pin. - A branded propeller or a drone kit. ## Requirements Each requirement has an id. Checks name the id they cover. ### R1. Gap, sweep, balance - At rest, the axle is clear of the hub by `gap` within 0.05 mm, so the print does not weld. - A 36-step rotation about the axis shows no illegal intersection with the cap or the stand. - The first moments of the blade-and-hub solid about the axis, uniform density, are under the bound in `design.md` (near-zero imbalance). Accept when: the gap, the sweep, and the moments match the file. ### R2. Files and frames - A single print-in-place mesh (voids at the gap). Renders: rest, a mid-spin pose, a section, and the stand. - One command builds, sweeps, balances, and writes the renders. No flight, no print, no motor. Accept when: the command passes for both tools, a zero-gap input fails the weld check, and a deliberately heavy one-sided fixture fails the moment bound. ### R3. Inputs - Numeric inputs are read from `spekkr.inputs.json` and must stay inside the ranges in the Inputs table in `design.md`. - A value outside a range is refused before modelling, with a message that names the key. - Options add or remove the features in that table. The `tool` swap selects CadQuery or OpenSCAD; both must meet the same numbers. Accept when: default and one out-of-range value are handled as above, and a second legal input set still matches the formulas in `design.md`. ### R4. Checks and report - One command builds the model at the defaults and at the person's inputs, measures it against `design.md`, and writes a short report. - A model broken on purpose, for example a wall thinner than `wall`, must fail the report. - The command exports the files this spec asks for (STL, and STEP when the tool can). No physical print is required. Accept when: the report says pass at the defaults and at the person's inputs, and fail on a deliberately broken model. ## Verification Axle and hub clearance, a rotational sweep without illegal intersection, and approximate mass balance (moments about the axis) are checked on the model. Renders are written. Flight is out of scope. No physical print and no motor are required. ## Definition of done - Every acceptance check above runs from one command, and all pass at the person's inputs. - A README says how to export the piece, how the gap is meant to print, and that flight is not a check.