# Tasks Work in order. Finish a task's check before starting the next. 1. **Set up.** Install the tool in the `tool` input. Decide on each part and its footprint, and write them down in the parts list. Check: an empty circuit writes an empty netlist. 2. **Socket and CC resistors (R1, R2).** With `data_lines` deciding which socket. Check: the R1 and R2 checks pass. 3. **Protection and capacitors (R3, R4).** Use the `max_current` input. Check: the R3 and R4 checks pass. 4. **Sense outputs (R5).** Only if `detect_current` is on. The two resistors, and the function with its table of cases. Check: every case in `design.md` gives its answer. 5. **Data (R6) and the light (R7).** As `data_lines` and `power_led` say. Check: the R6 and R7 checks pass. 6. **What comes out (R8).** Check: the R8 check passes. 7. **The check itself (R9).** Break the circuit the three ways R9 names and see each one caught. Check: the R9 checks pass. 8. **Finish.** Write the README and run the command from a clean folder. Check: every item under "Definition of done" in `spec.md` is true.