# Design This file fixes the geometry. How the model's code is organised is up to you, as long as the numbers here hold. ## Constants The link table (crank, rockers, shins, feet) is `fixtures/walker-links.json`, in millimetres at scale 1. These are original constants for this spec, not a copy of a patented table presented as a product name. ## Path The expected foot path is a closed loop, flatter at the bottom (the stance), in the fixture file. Tolerance 0.5 mm at scale 1. ## Inputs | Key | Label | Default | Notes | | --- | --- | --- | --- | | `scale` | Scale | 1.0 | A multiplier on the documented link lengths, from 0.5 to 2. | | `thickness` | Bar thickness, mm | 4.0 | From 2 to 8. | | `clearance` | Joint clearance, mm | 0.3 | From 0.2 to 0.5. | | `legs` | Eight legs | on | If off, a single four-bar demo is built, still enough for the path check. | | `crank_handle` | A crank handle | on | A handle to turn the crank in a desktop model. | | `tool` | Modelling tool | cadquery | CadQuery writes STEP and STL. OpenSCAD writes STL. | ## Acceptance at the defaults Millimetres. Default span 240, leg length 120, eight legs on, crank handle on. This is an original linkage, not a copy of a named walking machine. | Quantity | Value | Tolerance | Source | | --- | --- | --- | --- | | Overall span, feet planted | 240.00 | 0.40 | Left-most to right-most foot | | Leg length, hip to foot | 120.00 | 0.20 | Along the longest bar | | Crank radius | 16.00 | 0.10 | Of the driving crank | | Foot path, horizontal travel | 36.00 | 0.40 | One stride of a foot in the air | | Foot path, ground contact flatness | 1.00 | 0.20 | Z wander while planted | A full crank turn is simulated in code. Each foot's path is written to a CSV and compared to the documented stride. If `legs` is off, a single four-bar still has to match the path check. No physical cranking is required. ## Screenshots These pictures are headless OpenSCAD renders of the reference model in `reference/model.scad`, at the default inputs. They are not drawings of a product that has not been modelled. The first picture is the one Spekkr shows on the spec's card. A build may ship its own goldens; those goldens are of that build and do not have to match these frames pixel-for-pixel. | File | What it shows | | --- | --- | | `shots/walk.png` | Walker 240 mm span, eight legs | ## How to verify 1. Build the model at the default inputs and at two other legal input sets. 2. Measure every row of the acceptance table in this file; each must fall inside its tolerance. Use the solid itself or a mesh library on the exported STL, as `design.md` says for the chosen tool. 3. Refuse at least one out-of-range input by name before modelling. 4. Confirm each exported part is a manifold, watertight mesh, and that walls and print orientation hold where this file asks. 5. Linkage lengths match documented constants. The foot path and clearances over a full crank revolution are checked, including no illegal self-intersection. Gait renders at several angles are written. Walking on sand is out of scope. No physical print is required. The product name does not use a trademarked walking-sculpture name.